Monday, July 6, 2015

Rear Wings, Part 2

I was able to save just about everything and fabricate patches for the rusted out pieces.  I reused the metal from the other fender I cut off to make the patches for the inner fender, since it was a) intact and b) the right thickness.  I think it turned out ok.

Before... and after.

 

Now with the closing panel in place too.


 

And finally, with the outer panel installed.  It's not perfect; it's got some waves in it even though I was really careful with heat.  But it's close enough to straighten out with a little filler.

No comments:

Post a Comment

All comments are moderated and published upon review.